Cisco Router GRE Client Configuration

Tunnel Configuration

The GRE tunnel configuration on a Cisco Router is fairly easy.  If you are accepting a default route from us we suggest using a separate route table / VRF for either the tunnel network or your WAN interface.  The WAN interface is probably the easiest as the "front door VRF configuration" is fairly common.  You can see this in the Gigabit Ethernet 0/0/0 interface.

As you can see in the Tunnel interface configuration we are then anchoring the tunnel to that WAN interface with the tunnel source command.   Finally, take note if we are connecting with you over a publically routable address we will use a /31 or /30 under most circumstances.



interface GigabitEthernet0/0/0
 description WAN Interface
 vrf forwarding WAN_VRF
 ip address dhcp
 no cdp enable

interface Tunnel0
 description Tunnel to Core Transit
 tunnel source GigabitEthernet0/0/0
 tunnel destination 198.51.100.1
 ip address 192.0.2.1 255.255.255.254
 ip tcp adjust-mss 1400

 

 

Var dette svaret til hjelp? 1 brukere syntes dette svaret var til hjelp (1 Stemmer)

Mest populære

TP Link HX510 L2TP Client Configuration

TP Link HX510 L2TP WAN Configuration Summary In our testing, we added a new L2TP Internet...
Tested and Supported Devices

Tested & Supported Devices Mikrotik hAP AC Notes:Tested working with both L2TP and GRE....
Configure pfSense with Core Transit L2TP Tunnels

pfSense permits a lot of flexible firewall and routing configurations.  In this example, we have...
Cisco L2TP Configuration

To configure an L2TP tunnel on a Cisco router you can use this template configuration: !...
Linux xl2tpd L2TP Client Configuration

https://insidelinuxdev.net/article/a018fw.html has a good example under section 3 (ignore the...

Powered by WHMCompleteSolution